02 - RIDE INFO 2.1 Out the Box
This manual is not intended as a comprehensive guide to assembling,
servicing, or maintaining your bicycle. Please see your authorised Whyte Bikes
retailer for assembly guidance, service, repairs, and maintenance.
INFO: Specication of all the components that are tted to your bike
as standard may be obtained from the Whyte Bikes website www.
whytebikes.com
8
WARNING: If you are in any doubt about your ability to safely
service or repair your Whyte bike, DO NOT RIDE IT and instead
arrange for a professional bicycle mechanic at your local Whyte
retailer to do the job correctly.
WARNING: Before any ride check all xings are tight and secure. This
is very important to ensure the bikes performance and your safety.
Please read the Pre-Ride Checks section of this manual and learn
what is required to operate this bicycle. Correct tightening force
on fasteners (nuts bolts and screws) is critical. Too much force can
cause damage to the xing and too little force could cause them to
undo or rattle loose. Where indicated in the instructions or printed on
the xing please adhere to the recommended torque specication.
Please see below for recommended tools and torque settings.
Tools Required For Assembly:
• 4,5,6,8mm Allen key
• Adjustable spanner
• Bicycle Pump
• Torque Meter Wrench (Optional)
To Next Page
Loading...
