WIKA T15 - Page 20

EN
14139245.01 12/2015 EN/DE
WIKA operating instructions model T1520
5.6 Configuration
Configurable are
■
Sensor type
■
Sensor connection
■
Measuring range
■
Unit
■
Signalling
■
Measuring range monitoring
■
Damping
■
Write protection
■
“Several” TAG numbers
■
2-point scaling
The temperature transmitters are delivered with a basic configuration (see data sheet
TE 15.01) or configured according to customer specifications. If the configuration is
changed afterwards, the modifications must be noted on the product label using a water-
resistant fibre-tip pen.
A simulation of the input value is not required to configure the T15. A sensor
simulation is only required for the functional test.
5.6.1 Configurable monitoring functionality
Measuring range monitoring:
If this function is activated, an error is signalled on the current loop if the measured value is
either below or over the limits of the measuring range.
5.6.2 Configuration via the PC
Configuration is carried out using a USB interface with a PC via the model PU-448
programming unit (see chapter 11 “Accessories”) and the WIKAsoft-TT configuration
software.
The required Windows device driver for the PU-448 is installed automatically
during the installation setup of WIKAsoft-TT.
5. Commissioning, operation