EN
9WIKA operating instructions, models TRxx and TCxx
14150915.08 04/2024 EN/DE/FR/ES
3. Transport, packaging and storage
3. Transport, packaging and storage
3.1 Transport
CAUTION!
Damage through improper transport
With improper transport, damage to property can occur.
▶
When unloading packed goods upon delivery as well as during
internal transport, proceed carefully and observe the symbols on the
packaging.
▶
With internal transport, observe the instructions in chapter
3.2 “Packaging and storage”.
Check the instrument for any damage that may have been caused.
In the event of any damage, do not commission the instrument and contact the
manufacturer immediately.
If the instrument is transported from a cold into a warm environment, the formation of
condensation may result in instrument malfunction. Prior to recommissioning, wait for
the instrument temperature and the room temperature to equalise.
3.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in place of use, sending for repair).
Permissible conditions at the place of storage:
■
Storage temperature without built-in transmitter -40 ... +80 °C [-40 ... +176 °F]
■
Storage temperature with built-in transmitter: see the operating instructions for the
relevant transmitter
■
Humidity: 35 ... 85 % relative humidity (non-condensing)
To Next Page
Loading...
Need help?
General
