Wilden P200 - User Manual

EOM
ENGINEERING OPERATION
& MAINTENANCE
P200 Bolted
Plastic Pump
WIL-11070-E-15
Where Innovation Flows

Summary

Section 1: Precautions - Read First!

Section 2: Wilden Pump Designation System

Section 3: How It Works-Pump & Air Distribution System

Section 4: Dimensional Drawings

P200 Plastic - Polyurethane

Dimensional drawing for P200 Plastic pump with Polyurethane wetted parts.

P200 Plastic - PVDF

Dimensional drawing for P200 Plastic pump with PVDF wetted parts.

P200 Plastic - Polyurethane, Center Ported

Dimensional drawing for P200 Plastic center-ported pump with Polyurethane.

P200 Plastic PVDF, Center Ported

Dimensional drawing for P200 Plastic center-ported pump with PVDF.

Section 5: Performance

P200 Plastic Rubber-Fitted

Performance curves for P200 Plastic pump with rubber-fitted components.

P200 Plastic TPE-Fitted

Performance curves for P200 Plastic pump with TPE-fitted components.

P200 Plastic Reduced-Stroke PTFE-Fitted

Performance curves for P200 Plastic pump with reduced-stroke PTFE.

P200 Plastic Full-Stroke PTFE-Fitted

Performance curves for P200 Plastic pump with full-stroke PTFE.

Suction-Lift Curves

Charts detailing suction-lift capabilities of the P200 Plastic pump.

Section 6: Suggested Installation, Operation, Maintenance and Troubleshooting

Section 7: Disassembly; Reassembly

Pump Disassembly

Step-by-step guide for disassembling the pump.

Air Valve; Center Section Disassembly

Guide for disassembling the air valve and center section.

Reassembly Hints & Tips

Important tips and torque specifications for reassembly.

Section 8: Exploded View and Parts List

Section 9: Elastomer Options

Wilden P200 Specifications

General

Max. Pressure	125 psi (8.6 bar)
Pump Type	Air-Operated Double-Diaphragm
Air Inlet	1/2 inch NPT
Materials	Aluminum, Polypropylene, Stainless Steel
Diaphragm Materials	Buna-N, EPDM, Neoprene, PTFE