Your lift comes with (4) wheel safety stops. These insert at the end of each runway in the
same slot as your approach ramps. When using your approach ramps you will need to
remove the safety wheel stop. (Note:The hole in each of the safety stops was used
for powder coat process and does not get used in assembly process.)
Approach ramps can be used form either end of the lift. Simply insert the end into the
slot shown. We recommend that you remove the approach ramps before raising your lift.
Step 9: INSTALLING ACCESORIES
Your rolling bridge jack has a maximum capacity of 3,000Lbs
To install your rolling jack tray, use an allen wrench loosen all 4 axles. Align the grove in
the wheels with the center channel of the runway. Make sure all 4 wheels are centered
on the channel and the rolling jack tray is square. Keep the allen head screws slightly
To Next Page
Loading...
