Real-Time Auto ID
If ON, Auto-ID will run immediately after concluding a
recording and the Auto-ID pop-up will be displayed.
Default: ON
Real-Time Auto ID Sensitivity
Adjusts how conservative the ID results will be. On
SENSITIVE, more bats will be identified even if the algorithm
is less confident of the result. On ACCURATE, only bats in
which the algorithm is very confident will be shown.
BALANCED is in between.
Range: SENSITIVE, BALANCED, ACCURATE
Default: SENSITIVE
Trigger Sensitivity
Adjusts the recording trigger sensitivity level. High is
extremely sensitive and maximizes detection, but will also
trigger from other noises resulting in NOISE files. Low will
only trigger on stronger signals that are likely to be able to be
identified. Medium is somewhere in between the two
extremes. The trigger only applies to signals that are higher in
frequency that the Trigger Minimum Frequency setting in
the Spectrogram Settings panel.
Range: LOW, MEDIUM, HIGH
Default: MEDIUM
Trigger Window
The recording continues for this amount of time after the last
signal that satisfies the trigger. (The recording is also
truncated when it reaches the maximum recording duration
set by Max Trigger Length.) Set the trigger window setting
long enough to avoid a recording that ends after one
echolocation call. For example, if bat echolocation calls occur
To Next Page
Loading...
