Wilfa Narvik 25 - Product Specifications; Support and Spare Parts; Recyclability

13
English
button. Temperature of Celsius degree setting: 16-30; for Fahrenheit degree
setting: 61-86.
• Presetting temperature can be decreased. Press this button, the temperature
can be set up, continuously press this button and hold for two seconds, the
relative contents can quickly change, until unhold this button and send the
order that the ℃(℉) signal will be displayed all the time. The temperature
adjustment is unavailable under the Auto mode, but the order can be sent by if
pressing this button.
5. TURBO button
Under Cool or Heat mode, press this button can turn on or turn off the Turbo
function. After the Turbo function turned on, the signal of Turbo will display. The
signal will be automatically cancelled if changing the mode or fan speed.
6. button
Press this button to set left & right swing angle cycling as below:
7. button
Press this button to set swing angle, which circularly changes as below:
This remote controller is universal. If it receives threes kinds of following status, the
swing angle will remain original.
If guide louver is stopped when it is swinging up and down, it will remian its
present position.
indicates guide louver swings back and forth in the five places, as shown in the
figure.
8. CLOCK button
Press this button, the clock can be set up, signal blink and display. Within 5
seconds, the value can be adjusted by pressing + or - button, if continuously
press this button for 2 seconds above, in every 0.5 seconds, the value on ten place
ofMinutewill be increased 1. During blinking, repress the Clock button or Confirm
button, signal will be constantly displayed and it denotes the setting succeeded.
After powered on, 12:00 is defaulted to display and signal will be displayed. If
there is signal be displayed that denotes the current time value is Clock value,
otherwise is Timer value.
OFF
OFF