15
English
operation status. Press this button for the first time to start scavenging function;
LCD displays ” ”. Press the button for the second time to start healthy and
scavenging functions simultaneously; LCD displays ” ” and ” ” Press this button
for the third time to quit healthy and scavenging functions simultaneously. Press
the button for the fourth time to start healthy function; LCD display ” ”. Press this
button again to repeat the operation above.
NOTE: This function is not applicable for Nordic models.
12. I FEEL button
Press this button once, to turn on the I FEEL function, then the figure of ”I FEEL”
will be displayed, after every press of other function button, every 200ms to send I
FEEL once, after this function started, the remote controller will send temperature
to the main un it in every 10 minutes. When repress this button, this function will
be turned off. When I FEEL function is turned on, the remote controller should be
put within the area where indoor unit can receive the signal sent by the remote
controller.
13. LIGHT button
Press this button at unit On or Off status, Light On and Light Off can be set up.
After powered on, Light On is defaulted.
14. WIFI button
Press the WIFI button to activate the function. Press again to stop the function.
More info can be found in WIFI attachments and wilfa.no, wilfa.com
15. QUIET button
Press this button, the Quiet status is under the Auto Quiet mode (display and
”Auto” signal) and Quiet mode (display singal) and Quiet OFF (there is no signal
of displayed), after powered on, the Quiet OFF is defaulted. Under the Quiet
mode (Display ” ” signal).
The Quiet function is only available for some models.
16. SLEEP button
• Press this button, can select Sleep 1( ),Sleep 2 ( ),Sleep 3 ( ) and cancel
the Sleep, circulate between these, after electrified, Sleep Cancel is defaulted.
• Sleep 1 is Sleep mode 1, in Cool, Dehumidify modes: sleep status after run for
one hour, the main unit setting temperature will increase 1℃, 2 hours, setting
temperature increased 2℃, the unit will run at this setting temperature; In
Heat mode: sleep status after run for one hour, the setting temperature will
decrease 1℃, 2 hours, setting temperature will decrease 2℃, then the unit will
run at this setting temperature.
To Next Page
Loading...
