18
English
Childlock function
Press ”p” and ”q” simultaneously to turn on or turn off child lock function. When child lock function is on, ”
” icon is
displayed on remote controller. If you operate the remote controller, the ”
” icon will blink three times without sending signal
to the unit.
Temperature display switchover function
Under OFF status, press ”q” and ”MODE” buttons simultaneously to switch temperature display between °C and °F .
WIFI function
Press the WIFI button to activate the function. Press again to stop the function. More info can be found in WIFI attachments
and wilfa.no, wilfa.com
OPERATION GUIDE
1. After putting through the power, press ”ON/OFF” button on remote controller to turn on the air conditioner.
2. Press ”MODE” button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press ”p” or ”q” button to set your required temperature. (Temperature can’t be adjusted under auto mode).
4. Press ”FAN” button to set your required fan speed: auto, low, medium and high speed.
5. Press ”SWING” button to select fan blowing angle.
REPLACEMENT OF BATTERIES IN REMOTE CONTROLLER
1. Press the back side of remote controller marked with “ “, as shown in the fig, and
then push out the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar and
“-” polar are correct.
3. Reinstall the cover of battery box.
Note:
• During operation, point the remote control signal sender at the receiving window on indoor unit.
• The distance between signal sender and receiving window should be no more than 8m, and there should be no obstacles
between them.
• Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
• Replace new batteries of the same model when replacement is required.
• When you don’t use remote controller for a long time, please take out the batteries.
• If the display on remote controller is fuzzy or there’s no display, please replace batteries.
Signal sender Battery
Reinstall
Remove
Cover of battery box
To Next Page
Loading...
