17
English
setting sleep curve and blink;
4. Repeat the above step (2)~(3) operation, until 8hours temperature setting
finished, sleep curve setting finished, at this time, the remote controller will
resume the original timer display; temperature display will resume to original
setting temperature.
• Sleep3 - the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting
sleep curve, enter into user individuation sleep setting status, but do not
change the temperature, press ”Turbo” button directly for confirmation.
Note: In the above presetting or enquiry procedure, if continuously within10s,
there is no button pressed, the sleep curve setting status will be automatically
quit and resume to display the original displaying. In the presetting or enquiry
procedure, press ”ON/OFF” button, ”Mode” button, ”Timer” button or ”Sleep”
button, the sleep curve setting or enquiry status will quit similarly.
To Next Page
Loading...
