19
English
EMERGENCY OPERATION
If remote controller is lost or damaged, please use auxiliary button to turn on or turn off the air conditioner. The operation in
details are as below: As shown in the fig. Open panel, press aux. button to turn on or turn off the air conditioner. When the air
conditioner is turned on, it will operate under AUTO mode.
Warning: Use insulated object to press the auto button.
CLEAN AND MAINTENANCE
Warning:
• Turn off the air conditioner and disconnect the power before cleaning the air conditioner to avoid electric shock.
• Do not wash the air conditioner with water to avoid electric shock.
• Do not use volatile liquid to clean the air conditioner.
Clean surface of indoor unit
When the surface of indoor unit is dirty, it is recommended to use a soft dry cloth or wet cloth to wipe it.
Note: Do not remove the panel when cleaning it
Cleaning filter
1. Open panel
Pull out the panel to a certain angle as
shown in the fig.
3. Cleaning filter
• Use dust catcher or water to clean the filter.
• When the filter is very dirty, use the water (below 45°C ) to clean it, and
then put it in a shady and cool place to dry.
2. Remove filter
Remove the filter as in- dicated in the fig.
4. Install filter
Install the filter and then close the panel cover tightly.
Warning:
• The filter should be cleaned every three months. If there is much dust in the operation environment, clean frequency can
be increased.
• After removing the filter, do not touch fins to avoid injury.
• Do not use fire or hair dryer to dry the filter to avoid deformation or fire hazard.
Note: Checking before use-season
1. Check whether air inlets are blocked.
2. Check whether air switch,plug and socket are in good condition.
3. Check whether filter is clean.
4. Check whether drainage pipe is damaged.
Note: Checking after use-season
1. Disconnect power supply.
2. Clean filter and indoor unit’s panel.
Aux. button
Panel
To Next Page
Loading...
