16
English
• Sleep 2 is sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
In Cool mode:
1. When setting the initial temperature 16℃-23℃, after turned on Sleep
function, the temperature will be increased 1℃ in every hour, after 3℃
the temperature will be maintained, after 7hours, the temperature will
be decreased 1℃, after that the unit will keep on running under this
temperature;
2. When setting the initial temperature 24℃-27℃, after turned on Sleep
function, the temperature will be increased 1℃ in every hour, after 2℃
the temperature will be maintained, after 7hours, the temperature will be
decreased 1℃, after that the unit will keep on running under this temperature;
3. When setting the initial temperature 28℃-29℃, after turned on Sleep
function, the temperature will be increased 1℃ in every hour, after 1℃
the temperature will be maintained, after 7hours, the temperature will be
decreased 1℃, after that the unit will keep on running under this temperature;
4. When setting the initial temperature 30℃, under this temperature setting,
after 7hours, the temperature will be decreased 1℃, after that the unit will
keep on running under this temperature;
In Heat mode:
1. Under the initial presetting temperature 16℃, it will run under this setting tem
perature all along.
2. Under the initial presetting temperature17℃-20℃, after Sleep function
started up, the temperature will decrease 1℃ in every hour, after 1℃
decreased, this temperature will be maintained.
3. Under the initial presetting temperature 21℃-27℃, after Sleep function
started up, the temperature will decrease 1℃ in every hour, after 2℃
decreased, this temperature will be maintained.
4. Under the initial presetting temperature 28℃-30℃, after Sleep function
started up, the temperature will decrease 1℃ in every hour, after 3℃
decreased, this temperature will be maintained.
• Sleep 3 - the sleep curve setting under Sleep mode by DIY:
1. Under Sleep 3 mode, press ”Turbo” button for a long time, remote controller
enters into user individuation sleep setting status, at this time, the time of
remote controller will display ”1hour”, the setting temperature ”88” will
display the corresponding temperature of last setting sleep curve and blink
(The first entering will display according to the initial curve setting value of
original factory);
2. Adjust ”+” and ”-” button, could change the corresponding setting
temperature, after adjusted, press ”Trubo” button for confirmation;
3. At this time, 1hour will be automatically increased at the timer postion on the
remote controller, (that are ”2hours” or ”3hours” or ”8hours”), the place of
setting temperature ”88” will display the corresponding temperature of last
To Next Page
Loading...
