Installation
14 WILO SE 05/2021
English
5 Installation
5.1 Mechanical installation
Installation site Provide a weatherproof, frost-free, dust-free and
well-ventilated room for the installation. Choose
an installation site that is easily accessible.
1. Prepare the installation site so that the pump
can be installed without being exposed to
mechanical stresses.
2. Choose the right installation position – only
as shown in figure A.
The arrow on the rear of the housing indicates
the direction of flow.
DANGER: Before starting work, make sure
that the pump has been disconnected from the
power supply.
CAUTION: Dirt can cause the pump to fail.
Flush the pipe system before installation.
NOTICE: The ball shut-off valve and
non-return valve are pre-installed. Additional
stop valves are not necessary.
To Next Page
Loading...
