Wilo Wilo-Para Series - Manual Restart Procedure

Installation and operating instructions Wilo-Para 51
en
Manual restart • The pump attempts an automatic restart upon
detecting a blockage.
If the pump does not restart automatically:
• Activate manual restart via the operating button:
press and hold for 5 seconds, then release.
The restart function is initiated, and lasts
max. 10 minutes.
The LEDs flash in succession clockwise.
• To cancel, press and hold the operating button
for 5 seconds.
If the fault cannot be remedied, contact a specialist
technician or Wilo customer service.
sec5
min10
NOTICE
After the restart, the LED display shows the
previously set values of the pump.