25
Wilson Audio Specialties
s e C T i O n 2 . 1 — u n C r A T i n g T h e A l e x i A
Note: You will have two Upper Array enclosures as well as two Woofer Module enclo-
sures to unpack. The two modules will need to be separated into right and left chan-
nels. Clear out two spaces, one for your left and one for your right channels. Place
the ODD numbered modules in the LEFT channel section and the EVEN in the RIGHT
channel position.
Section 2.1—Uncrating the Alexia
Initial Check
The Alexia is shipped in three wooden crates. Upon receiving these crates, please
check their condition. If any of the crates are damaged, please report it to the shipping
company immediately for insurance verification.
The following items are recommended for this procedure:
• Electric Screwdriver
• Phillips head drive bit
• Masking tape (for use in speaker setup)
Uncrating the Woofer Module
A minimum of two strong adults is required to set up the Alexia. Locate the two
largest crates labeled “Woofer Module.” These contain the woofer enclosures and are
the first components of the system to unpack.
1. With the crate lid facing up, unscrew the wood screws securing the lid. Re-
move the lid.
2. Carefully rotate the crate upright so that the Woofer Module is now verti-
cal. With the Woofer Module’s bottom toward the floor, reach in and gen-
tly roll the Woofer Module out of the crate, carefully, so as not to hit the
Woofer Module on the crate and scratch the paint.
3. Place the Woofer Module with an odd serial number on the left side of the
To Next Page
Loading...
