31
Wilson Audio Specialties
s e C T i O n 3 . 1 — i n i T i A l A s s e M b l Y
Note: Before setting up the Alexia, study carefully Section 1, “In Your Room.” It pro-
vides valuable information on determining the ideal room location for your speakers.
Section 3.1—Initial Assembly
Preparation
You will need the following items:
• Supplied hardware kit
• Tape measure
• Propagation Delay Correction Tables (Section 8)
• Known listening position
• Masking Tape
Take a moment to familiarize yourself with the top of the Woofer Module. A com-
plete set of Propagation Delay
Correction Tables is located in
Section 8.
Upper Array Assembly
The Upper Array uses the
combination of a captive spike
or the addition of one of three
different length accessory spikes
installed into the bottom of its
enclosure. The spikes rotate the
Upper Array to a scribed position
as a part of the Alexia’s propaga-
figure 4—instAll “AA” spikes in frOnt� instAll ApprO-
priAte AlignMent spike in the reAr Of upper ArrAY�
“AA” SpikeS
To Next Page
Loading...
