57
Wilson Audio Specialties
s e C T i O n 6 . 1 – T r O u b l e s h O O T i n g
Section 6.1 – Troubleshooting
One channel is not operating:
Imaging is off-center:
A chronic lack of bass energy:
Driver out or not playing after connec-
tions have been verified:
Check the interconnects from source.
Check the connections on the speak-
er cables, both at the amplifier and
speaker ends. Watch especially for
connectors touching each other.
Check the umbilicals that connect the
two modules. You may have forgotten
to connect them, or they may have
shorted or come loose during setup.
Check your connections. A connec-
tion to one of the modules may have
come loose. When a tweeter or mid-
range driver is not working, or is out
of phase, the Alexia will not “image”
properly. Double check your con-
nections for red-to-red and black-to-
black.
Play music at a low level and listen
to each driver in each channel. You
may have a driver that is not oper-
ating correctly. If you find a driver
that is silent, please go to the “Driver
Out” section of this troubleshooting
guide.
Check the input cable connections on
your woofer enclosure. If one chan-
nel is out of phase (connections re-
versed), bass will be cancelled. Note:
Turn off your amplifier and unplug it
from the wall.
If you have found a driver with no
output, move to the rear of this par-
ticular loudspeaker.
To Next Page
Loading...
