A l e x i A O w n e r ’ s M A n u A l
58
Wilson Audio Specialties
Amplifier shuts off as soon as it is turned
on:
If the problem is solved:
If the problem persists:
Using the appropriate Allen key, open
the X-material door on the bottom of
the Upper Array module.
You will find some resistor connec-
tions. Replace the resistor with the
supplied matching resistor. Tight-
en the new resistor in the old one’s
place. The woofer resistor may be re-
placed in the same manner and is lo-
cated behind the access door in the
bottom of the Woofer Module.
Note: Use only Wilson Audio re-
placement resistors in Alexia. These
resistors were carefully chosen for
the overall sonic and thermal perfor-
mance.
Plug your amplifier into the wall and
turn it on.
Listen to the channel at a low level.
The driver should now be operating
correctly.
Check to see if your speaker cables
are properly secured. Look for frayed
ends, loose connections, or a conduc-
tor contacting the amplifier chassis.
Turn the amplifier off and disconnect
it from the AC wall outlet. Discon-
nect the preamplifier leads to the am-
plifier. Now turn on the amplifier.
There is likely something wrong with
your preamplifier or interconnect.
Contact your dealer.
Leave the preamp leads disconnected
and continue to the next step.
To Next Page
Loading...
