A l e x i A O w n e r ’ s M A n u A l
26
Wilson Audio Specialties
room and the Woofer Module with an even serial number on the right side
of the room.
Note: These two woofer enclosures are very heavy and care should be taken to pre-
vent injury. Roll the Woofer Module with drivers facing forward for the best stability.
Uncrating the Upper Array
The Upper Arrays are contained in a single crate. Unpack the modules using the
following procedure:
1. With the crate lid facing up, unscrew the wood screws securing the lid. Re-
move the lid.
2. The Upper Array crate contains the owner’s manual and tool kit. Remove
these.
3. Make sure the thumb bolt that secures the Tweeter is tight before moving.
4. When removing the upper modules, take care so as not to hit the modules
on the crate and scratch the paint. Using the small shelf on the rear of the
module, tilt it so there is access to the bottom side. Slide the other hand
under the Upper Array for support, and carefully lift the enclosure out of
the crate.
5. The cloth grilles are attached to the modules. Detach the grilles from the
module and remove the protective plastic covering the grill.
6. Place the Upper Array with an odd serial number on the left side of the
room and the Upper Array with an even serial number on the right side of
the room.
Section 2.2—Crate Content Checklist
Now that you have unpacked your Alexias, you can inventory all the additional
To Next Page
Loading...
