To Next Page

To Previous Page

Need help? www.WilsonElectronics.com Tech Support 866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

Lightning

Surge Protector

(sold separately)

To Outside

Antenna

To Signal Booster

Ground Wire

(not included)

RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR

(SOLD SEPARATELY)

INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL

BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE

SURGE PROTECTOR. ENSURE THE LSP IS PROPERLY GROUNDED.

#859992-75 OHM MAY BE PURCHASED AT WWW.WILSONELECTRONICS.COM

OR BY CALLING 800-204-4104.

Signal Booster Specifications

SIGNALBOOST™ DBPro™ Specifications

Model Number 460005

Outside antenna connectors F-Female

Outside antenna impedance 75 Ohms

Inside antenna connectors F-Female

Inside antenna impedance 75 Ohms

Dimensions 6.5 x 4.25 x 1.75 inch (16.5 x 10.7 x 4.4 cm)

Weight 0.47 lbs (0.213 kg)

Frequency 824-894 MHz / 1850-1990 MHz

Power output 800 MHz 1900 MHz

Power output for single cell phone (uplink) dBm 24.9 22.5

Power output for single received channel (downlink) dBm -2.2 -2.1

Noise Figure (typical) 3.5 dB nominal / 6 dB nominal

Isolation (uplink/downlink) > 90 dB

Power Requirements 110-240 V AC, 50-60 Hz, 8 W

Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling

the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal

Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an

oscillation, the Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation

after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted

by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s microprocessor.