EasyManuals Logo

Wilson Electronics weboost Home Complete User Manual

Default Icon
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
18
HOME COMPLETE CELL PHONE SIGNAL BOOSTER
______
Specifications
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut o until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met. This device
complies with Part 15 of FCC rules. This device contains licence-exempt transmitter(s)/receiver(s that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may
not cause interference, and (2)) This device must accept any interference, including interference that may cause undesired operation of
the device. Changes or modifications not expressly approved by weBoost could void the authority to operate this equipment.
Home Complete
Model Number 460060
FCC ID PWO460060
IC ID
4726A-460060
Connectors F-Female
Antenna Impedance 75 Ohms
Frequency 698-716 MHz, 729-746 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Power output for single cell
phone (Uplink) dBm
700 MHz
Band12/17
700 MHz
Band13
800 MHz
Band 5
1700 MHz
Band 4
1900 MHz
Band 25/2
25.6 25.2 25.8 25.2 25.2
Power output for single cell
phone (Downlink) dBm
700 MHz
Band12/17
700 MHz
Band13
800 MHz
Band 5
2100 MHz
Band 4
1900 MHz
Band 25/2
13.6 13.3 12.7 12.9 12.5
Noise Figure 5 dB nominal
Isolation > 110 dB
Power Requirements 5 VDC
NEED HELP?
support.weboost.com 1-866-294-1660

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wilson Electronics weboost Home Complete and is the answer not in the manual?

Wilson Electronics weboost Home Complete Specifications

General IconGeneral
BrandWilson Electronics
Modelweboost Home Complete
CategoryExtender
LanguageEnglish

Related product manuals