© by WilTec Wildanger Technik GmbH Seite 5
http://www.WilTec.de
http://www.aoyue.eu Februar 2020 Version 2
http://www.teichtip.de
14. To secure the proper functioning of the device the UV-quartz tube should be replaced after 8000
operating hours.
15. If the upper part is blocked by sand, the quartz tube can be destroyed. Please place the filter
sponge in the inlet of the water pump.
16. UV-light is harmful for the eyes and skin. Do not look directly into the UV-light and do not expose
your skin to it.
17. If you install the device or repair it, switch off the power supply of the lamp and the pump.
18. The device must be installed on a horizontal flat surface with the feet downwards. For safety
reasons it not allowed to install the device otherwise.
Application area / Functioning
This UVC-device ensures clear water for healthy fish. The water is conveyed by a pump through the
UVC-device. There it flows past the UV-lamp and is exposed to UVC-radiation. This way the bacteria,
germs and floating algae in the water are destroyed and the water becomes clear.
To achieve an optimal result the device should be operated 24 hours in the frost-free seasons.
Commissioning
Switch on the pump and wait until the device is filled with water. Check if all connections are well sealed.
By plugging in the power cable the device you put the device into operation.
Technical data
Safety
• This device dangerous radiation. Direct contact to skin and eyes may is harmful and must be
avoided.
• If the pond filter is damaged it must not be operated.
• When no water is conveyed the device must be switched off.
• By frosty weather the device must be removed and kept dry in a place free of frost.
To Next Page
Loading...
Need help?
General
