Why there is oil in compressed air of Winco DE4040F4?
If there is oil in the compressed air from the Winco Portable Generator, this could be due to a soiled oil extraction line with a nozzle in the oil sight glass, a defective fine separator cartridge, or the oil level in the oil reservoir being too high, possibly due to excessive condensation.
Why will my Winco Portable Generator ATS not re-transfer to normal power?
If the ATS will not re-transfer to normal power for the Winco Portable Generator, it could be due to proper power line not being available at line terminals in the ATS panel or a defective ATS control board.
What causes differential pressure in Winco DE4040F4 Portable Generator?
Differential pressure in the Winco Portable Generator can be caused by pressure in the separator cartridge being too high, often associated with a clogged or full separator cartridge.
Why Winco DE4040F4 Portable Generator system does not relieve?
If the Winco Portable Generator system does not relieve, this could be due to issues with the solenoid valve or electrical system, or problems with the impulse-pressure relief valve.
Why does oil escape during discharge in my Winco DE4040F4 Portable Generator?
If oil escapes during discharge, creating oil foam in the separator cartridge of the Winco Portable Generator, the cause could be the oil type being incorrect, oil foam forming during stops, or the oil level being too high.
Why does Winco DE4040F4 Portable Generator control valve constantly discharge?
If the control valve constantly discharges in the Winco Portable Generator, the cause may be related to the solenoid valve or the electrical system.
General| Model | DE4040F4 |
|---|---|
| Type | Portable Generator |
| Frequency | 60 Hz |
| Phase | Single |
| Fuel Type | Gasoline |
| Starting System | Recoil |
| Weight | 108 lbs |
| Power Output | 4000 Watts |
| AC Maximum Output Watts | 4000 Watts |
| Voltage | 120/240 |
| Engine Type | OHV |
| Maximum AC Output | 4000 W |
| Noise Level | 68 dB |
To Next Page
