14
Operations
Controls
1. Main Handle. Used to pull and maneuver machine
2. Electrical Cord.
3. Pump Switch. Turns on pump and enables spray.
4. Brush/Spray switch. Turns on brush motor and
activates electro-valve to dispense solution to floor
through jets. Intermittent, off, and continuous
settings.
5. Vacuum Motor Switch. Turns on vacuum motor
6. Brush Motor Circuit Breaker. 6 amp. Breaker
protecting brush motor.
7. Vacuum Motor Circuit Breaker. 15 amp. Breaker
protecting vacuum motor.
8. Recovery Dump Hose. Facilitates draining dirty
cleaning solution.
9. Solution Dump Hose. Facilitates draining excess
cleaning solution from solution tank.
8-640-407-0 Manual, Operators CDT7I - 230V
2
1
6
4
7
8
9
To Next Page
Loading...
Need help?
General
