Adding a SIM Card (continued)
Step 2 - Locate the SIM card slot on the backside of the Gateway. A portion of
the Winegard FreedomGo SIM card (SIM0) is exposed. It is not necessary to
remove this SIM as Winegard Data is always available for purchase.
Step 3 - In the upper slot (SIM1) of the dual SIM Connector, insert the NEW
carrier’s SIM card with the metal electronic chip facing the electronics board
and the angled corner in the correct position, as shown below. If the SIM is
inserted incorrectly the SIM will not be recognized and an error code will be
displayed on the Status page.
Step 4 - Turn the Gateway power switch on.
Step 5 - Return to the Status page of the Winegard
software by following steps 1-3 on page 8. Next,
navigate to the Change Provider page. Select the SIM
SELECTION drop down menu and choose the correct
SIM. Verify that the correct cellular provider is listed in
the CELLULAR PROVIDER field and that the correct
APN from the table below matches. Once verified click
on the Change Provider button.
Cellular
Provider
APN
(Access Point Name)
T-Mobile fast.t-mobile.com
Verizon vzwinternet
AT&T broadband
18
1 2
3
Reset
Power
Ethernet
4 5 6
Dual SIM
Connector
Place in
upper slot
Angled
corner out
SIM
Red
Yellow
Green
To Next Page
Loading...
Need help?
General
