Winegard Gateway GW-1000 User Guide

Step 11 - Slide the ground wire from the vehicle into one end of the barrel crimp
splice and slide the black ground wire from the Gateway into the opposite end
of the splice. Crimp the splice.
Step 12 - Mount the wall plate to the wall or panel with the two supplied wall
plate screws.
Step 13 - Now is time to connect the exterior antennas to the Gateway.
Connect the WiFi cable with the red tubing to the mating connector that is
designated in the #2 slot.
Step 14 - Connect the 4G LTE cables with their respective mating connectors
(Yellow - #4 slot and Green - #5 slot).
Step 15 - Before connecting the power cable to the Gateway confirm that all
other connections are properly made. If so, connect the power cable. Turn
the wall plate power switch to the ON position and verify that the LED on the
backside of the Gateway illuminates.
Step 16 - Lastly, feed all excess
cabling back into the hole of the ceiling
and push the backside of the Gateway
up onto the mating hooks. There will be
two on the side opposite the cabling
hole and one on the same side as the
cabling hole. Once the Gateway is
secure to the hooks, slide the Gateway
towards the release lever until it locks
into place. A clicking sound indicates
the Gateway is locked in position.
Installation (continued)
1 2
3
Reset
Power Ethernet
4 5 6
Dual SIM
Connector
Place in
lower slot
Angled
corner out
SIM
Red
Yellow
Green
6
Release lever
1
2

Winegard Gateway GW-1000 Specifications

General

Brand	Winegard
Model	Gateway GW-1000
Category	Wireless Router
Language	English