56
Positioner Does Not Respond
If the positioner does not respond to commands, proceed as follows:
1. Unplug positioner from AC power for 3 seconds, then plug positioner back
into AC power. The positioner will display the normal menu. See Figure 8.
Model RD-9900
PINNACLE
POSITIONER
by WINEGARD
SELECT B
SELECT A
Figure 8
1. Press SELECT B Park
Search XXXXXX
Park
Name of search satellite
2. Press [SELECT B] Park to put antenna into the park position. See Fig. 8.
3. Visually verify that antenna is in correct park position.
If antenna does not go to the correct park position or fails to respond after
being unplugged and then plugged in again, contact Winegrad Service Dept.
To Next Page
Loading...
