SECTION 2
DRIVING YOUR MOTOR HOME
2-8
Power Electric Mirrors
The electric mirrors are adjusted using a
multi-directional switch located on the driver
sidewall armrest panel.
Select the mirror to be adjusted by pushing the
switch in the middle of the control to the right or
left. Then press the arrow buttons as necessary to
obtain the best view.
When mirrors are adjusted to preference,
place the selector switch back in the middle posi-
tion to cancel power to the buttons. This prevents
accidental misadjustment of mirror settings.
The mirrors also contain heating elements to
defog or de-ice the mirror glass during cold
weather operation. An ON-OFF switch for the
mirror heaters is located near the remote mirror
controls.
The power mirror control switch is intended
for fine adjustment of the mirrors. If you cannot
adjust a mirror properly using the control switch,
the mirror may need a coarse adjustment by repo-
sitioning the mirror head. See the mirror manu-
facturer’s instructions in your Owner InfoCase.
More Info - To read more about power mirrors,
see the mirror manufacturer’s information in
your Owner InfoCase.
SONY REARVIEW
MONITOR SYSTEM -
Optional
If your motor home is equipped with this op-
tional system, refer to the Owner InfoCase for
specific instructions provided by Sony.
ELECTRONIC COMPASS & OUTSIDE
THERMOMETER
COMPASS OPERATION
The compass has two (2) buttons - MODE
and °F/°C - which are used to change the unit
between the various operating modes.
Ignition On Operation:
1. Unit displays outside temperature and com-
pass heading.
2. Press the °F/°C button to toggle between dis-
playing °C and °F.
3. If the unit has been properly calibrated, the
heading will remain ‘on’ continuously. If the
Mirror
Heat
Switch
Mirror
Adjustment
Control
Power
Window
Switch
To Next Page
Loading...
Need help?
General
