What to do if my Winterwarm Heater heat exchange sensor or flue sensor not detected?
If the heat exchange sensor or flue sensor is not detected or shows a short circuit in your Winterwarm Heater, the heat exchange sensor consists of two internal sensors. The readings of these sensors may differ too much: measure the resistance of each sensor. The KΩ at 20 °C. If the measured values differ too much, replace the sensor.
What to do if the Winterwarm Heater flame detected before opening the gas valve?
If a flame is detected in your Winterwarm Heater before the gas valve opens, first check if there really is a flame before ignition and replace the gas valve if so. Also, check if the ionisation electrode is wet and dry, clean, or replace the electrode if needed.
Emphasizes installation by authorized personnel and compliance with regulations.
Outlines pre-installation checks including data badge verification and space requirements.
Specifies requirements for locating the heater, including clearance, distance, orientation, and suspension options.
Explains how to connect an MTS or MTC thermostat to the air heater.
Lists compatible flue terminals for vertical discharge with article numbers.
Details maximum straight flue lengths for horizontal and vertical orientations, considering bends.
Details the preparation and steps for installing a roof flue terminal.
Describes the pressure switch function for checking combustion air passage.
Outlines checks and adjustments needed for proper combustion efficiency after installation.
Guides the process of commissioning the air heater after installation.
Details how to adjust gas valve settings for high and low fire using a calibrated analyzer.
Lists volatile lock-out errors that require manual reset.
Describes temporary errors that resolve automatically once the cause is fixed.
Addresses flame detection issues lasting only 5 seconds after ignition.
Covers scenarios where no flame is detected after ignition.
Deals with overheating of heat exchange or flue sensors.
Addresses heat exchange or flue sensor not detected or short-circuit issues.
Details specific maintenance procedures for the burner unit, including electrode adjustment.
General| Brand | Winterwarm |
|---|---|
| Model | XR+ Series |
| Category | Heater |
| Language | English |
To Next Page
