Wise TSW200E1 - ROUND-TRIP DELAY Mode Configuration

To Next Page

To Previous Page

TSW200E1

5.9.1 - ROUND-TRIP DELAY Mode Configuration

The figure below displays the unframed circuits configuration screen.

FRAMED MENU

F1 F2 F3 F4

R O U N D -T RI P D E L AY

Interface:

Pattern:

Polarity:

Tx Clk Source:

Tx Rate:

RS232

NOR MAL

IN TER NAL

0064000 b ps

To toggle to the structured circuits setup screen, press <F1> (FRAMED). The following

screen will be shown:

The setup for structured mode has three screens. To navigate among the screens use <F4>

(NEXT) and <F1> (BACK) keys. A description of the setup parameters for the Round-Trip Delay

mode follows.

• Interface: Available for the non-framed mode only. Selects which interface to use. The

options are V.24/RS232, V35, V36, X.21, RS530 or G.703-2M. To change an option,

place the cursor at the proper line and use the → or ← keys to select the interfaces.

• Tx Clk Src: Can assume the following values:

 Internal: when the Test Set itself provides the transmit clock. In this case, the

external circuit must be prepared to receive external clock.

 External: when the transmit data are in sync with the external circuit clock. This

external circuit must be set up for internal or regenerated clock. For the G.703-

2M case, the external clock must be provided by the V.35 interface. Note:

Wise Telecommunications Industry 59