4 5
POWER SUPPLY PRECAUTIONS
1. Make sure the power supply is greater than 10A, otherwise overheating or fire may occur.
2. Do not use multiple electrical appliances in the same outlet.
3. Your Wisewell must be connected to a power outlet with a ground wire.
4. Never touch the power plug with wet hands. Always clean any dust or water stains from
the power plug to reduce the risk of electric shock and fire. Please ensure that the plug is fully
plugged into the outlet to avoid risk of electric leakage.
5. The power supply voltage must be consistent with the information on the product
packaging. A voltage stabilizer is recommended for areas with unstable voltage.
6. In addition to causing safety hazards, improper connection can cause the warranty clause
to become invalid.
7. To prevent fire, electric shock, or personal injury, do not immerse the power cord or outlet
in water.
POWER CABLE
1. Please use the original power cord to avoid safety hazards.
2. If your Wisewell malfunctions, unplug it, remove the water tank, and contact customer
service.
3. To avoid electric shock, do not bend or crush the power cord underneath heavy objects, and
avoid placing the cord where it can become a tripping hazard. If your Wisewell is not in use for
an extended period of time, unplug the power cord and store it in a safe place.
SAFE ENVIRONMENT
1. Do not expose your Wisewell to temperatures below 32°F/0°C to prevent the pipe from leaking.
2. The ambient temperature requirement is from 39°F/4°C to 100°F/38°C.
3. Keep your Wisewell away from direct sunlight. Do not use it in places with low temperatures
or flammable substances. To avoid damage to your Wisewell and water leaking, do not
disassemble your Wisewell.
4. Before using Wisewell at elevations above 4921 feet/1500 meters, the hot water
function should be disabled (see page 13).
DURING OPERATION
1. To prevent accidental burns, children and individuals with mobility impairments should not
operate the Wisewell.
2. When using the hot water feature, use caution when removing the cup to avoid burns.
3. To keep your Wisewell in good condition, be sure to use the accessories and
consumables provided by Wisewell.
4. While hot water is being dispensed, do not touch the water spout.
AFTER USE
1. If your Wisewell will not be in use for an extended period of time, empty the water from
the internal tank and unplug your Wisewell from the power supply. (Please refer to the
Maintenance section of this guide for more information on how to empty the tank). Filter and
drain three tanks of water before use.
2. Do not carry or move the Wisewell by the extraction part. Use the side handles to move your
Wisewell.
OTHER NOTES
1. Your Wisewell must be placed on a flat surface. Please drain the water from the internal tank
before moving it. Do not tilt by more than 45 degrees when moving or operating the Wisewell.
2. Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or aer using the system.
3. The use and installation of this system must comply with state and local laws and
regulations.
4. Do not place any objects over 4lbs (2kg) on the water tray.
IMPORTANT
Water source: Tap water
To Next Page
Loading...