WisyCom MTP60 - MTP60 FCC and Industry Canada Compliance Statements

MTP60 mul-band bodypack transmier
15
Statements regarding FCC and Industry Canada
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
WARNING: Wisycom srl. is not responsible for any changes or modifications not expressly approved by the
party responsible for compliance. such modifications could void the user’s authority to operate the equip-
ment.
The FCC and IC identifier is visible in the display when the device is switched on and it is also available by
accessing the Info> STD submenus.
EN
This device complies with Industry Canada license-exempt RSS-123 and RSS-210 standard. Operation is sub-
ject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter IC: 11967A-MTP60 has been approved by Industry Canada to operate with the an-
tenna types listed below with the maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
FR
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence RSS-123 et RSS-210. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Le présent émetteur radio IC: 11967A-MTP60 a été approuvé par Industrie Canada pour fonctionner avec
les types d’antenne énumérés ci-dessous et ayant un gain admissible maximal et l’impédance requise pour
chaque type d’antenne. Les types d’antenne non inclus dans cette liste, ou dont le gain est supérieur au gain
maximal indiqué, sont strictement interdits pour l’exploitation de l’émetteur.
Antenna types (50 Ohm impedance, max gain 2.1dBi)
AWF30-B1-507: band 470 - 547 MHz
AWF30-B1-590: band 547 - 663 MHz
AWF30-B8-950: band 940 - 960 MHz
This equipment complies has been evaluated for and shown compliant with the FCC and ISED RF Exposure
limits. The unit of measurement for RF exposure is Specific Absorption Rate (SAR). The FCC SAR limits for is
1.6W/Kg per 1g of tissue
The maximum SAR levels tested has been shown to be 1.2 W/kg at head with 0mm of separation distance
from the body.
This device operates on a no-interference, no-protection basis. Should the user seek to obtain protection
from other radio services operating in the same TV bands, a radio license is required. For further details,
consult Innovation, Science and Economic development Canada’s Client Procedures Circular CPC-2-1-28,
Voluntary Licensing of License-Exempt Wireless Microphones in TV Bands.