WiXHC MACH3 MK-ET Series User Manual

If your Ethernet card is connected to your computer via a router,
Please make sure your router IP address format is 192.168.1.xx ,
If not, modify your router IP address into 192.168.1.xx format.
Otherwise unable to communicate. Modify the IP address of the
router, and then manually set the IP address of the computer in
accordance with the above method.
After PC IP address is set up, open the Mach3
software "plug-in control"in the figure below the location of the
choice of a IP address, range: 180-195.(If you have only one set of
control card, skip this setting. Factory defaults IP:180)
Ethernet card connected to the router
The second step: Ethernet card Mach3 software IP address Setting
- 1 4 -
New Function

WiXHC MACH3 MK-ET Series Specifications

General

Brand	WiXHC
Model	MACH3 MK-ET Series
Category	Controller
Language	English