CONFIGURATION
Login
1. Start your computer. Connect an Ethernet cable between your computer and the
Wireless Access Point.
2. Make sure your wired station is set to the same subnet as the Wireless Access Point,
i.e. 192.168.100.12.
3. Start your WEB browser. In the Address box, enter the following:
??????????????????????
`
`
`
The configuration menu is divided into four categories: Status, Wireless, TCP/IP,
and Other settings. Click on the desired setup item to expand the page in the main
navigation pane. The setup pages covered in this utility are described below.
11
To Next Page
Loading...