Operating manual PMF/GMF Page 30 of 37 B0343
7.2 Refilling the reservoir
If the equipment is operating with oil, refill directly into the reservoir.
If the equipment is operating with grease, refilling by filling pump through the filling inlet is
recommended. In this way, the medium is filled without air and dirt, to large extent.
Important! For opening the reservoir lid always follow the instructions from
chapter 5.3.1 of this operation manual!
Important! For refilling the reservoir from above through the opening always
ensure that the pump is switched off before opening the lid!
Important! With filling-level control and follow-up piston: Before re-filling the
tank, take out the follow-up piston from top and assemble, then!
7.3 Powering down
Powering down is by disconnecting the pump unit from the power supply.
To Next Page
Loading...
