821016: AMPx-E8 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
23
Chapter 2 System Overview
Monitoring Inputs
Monitoring an Analog Input
1. To monitor an analog signal, connect the analog input to the rear
panel Balanced Analog In (DB-25) connector.
2. On the front panel, press the Input button until the LCD screen
displays Analog.
3. Continue on to Channel Selection and Mixing on page 25.
Monitoring an AES Input
1. To monitor an AES signal, do one or both of the following:
• Connect an unbalanced AES signal to the rear panel AES/
PCM In
1 (BNC), and/or
• Connect a balanced AES signal to the rear panel AES Bal In
& Loop Out
(DB-25).
2. On the front panel, press the Input button until the LCD screen
displays the corresponding input you want to monitor:
• AES1 for an unbalanced signal (connected to BNC 1).
• AES2 for a balanced signal (connected to the DB-25).
3. Refer to Terminating/Unterminating Inputs on page 40 to check/
set your termination settings.
4. Continue on to Channel Selection and Mixing on page 25.
Note:
For a complete description of each front panel control, refer
to Front Panel Controls on page 8.
For a complete description of each rear panel connector,
refer to Rear Panel Connectors on page 14.
Table 2–9 AES Input to Channel Relationship
AES BNC Connector Channel Outputs
1 1 and 2
2 3 and 4
3 5 and 6
4 7 and 8
To Next Page
Loading...
