You can print out readings by transmitting them to
a thermal printer via the infrared interface.
In the normal Measuring mode, briefly press
the HOLD/MIN/MAX key to freeze the current
reading.
In the Hold mode, press and hold the
HOLD/MIN/MAX key for 2 seconds to begin
transmitting the data to the thermal printer.
NOTE!
Make sure the infrared interfaces of the fan ane-
mometer and the thermal printer are directly fac-
ing one another.
Data transmission and printout on the thermal
printer will begin. "Print" flashes in the display of
the fan anemometer as long as data is being
transmitted.
The values of all measurement channels are
printed out, not just those readings visible on the
display. Furthermore, the area of the air outlet
entered in the Setup menu will be printed, if there
is no funnel installed while printing. If the funnel is
installed while printing, the area cross section of
the funnel, on which the volume flow calculation
has been based, will appear on the printout.
Note!
After measuring with a funnel, printing should be
done while the funnel is still mounted.
The Date, Signature and Remarks fields are also
printed out for the operator to complete.
To Next Page
Loading...
