Operating the fan anemometer
To obtain a printout, press and hold the
HOLD/MIN/MAX key.
"Print" is shown in the display.
CAUTION!
After returning to the normal measuring mode, the
average values will no longer be shown. There-
fore we recommend to print them out for docu-
mentation.
To return to the normal Measuring mode,
press the Up key.
5.8.2 Multi-point average
In the normal Measuring mode, press and
hold the Up key for 2 seconds to access the
Multi-point average mode.
Fig. 11: Average value mode,
multi-point
A dot and AVG are displayed in the top part of the
display.
The number of stored measurement readings is
displayed in the top part of the display; the
current reading is displayed in the lower part
of the display.
To save a measurement reading, press the
HOLD/MIN/MAX key.
Repeat this process at various points.
Fig. 12: Average value display,
multi-point
When a sufficient number of measurement
readings have been saved, press the Up key
to display the average value.
AVG flashes.
Press the Down key to toggle between the
average values of the different measured
quantities.
To Next Page
Loading...
