CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
2 Bracket, mounting (stainless trim only)
10 Screw, #8-18 x
3
/
8
"
6 Screw, #6-18 x 1"
4 Screw, #6-32 x
3
/
4
"
2 Screw #8-15 x
1
/
2
"
3 Assembly, duct (bottom, rear, and top)
2 Trim, side
4 Tape, black foam
CONVECTION MICROWAVE - E SERIES TRIM INSTALLATION
1
For black trim, proceed to step 4.
2
Position the mounting brackets flush with the cabinet
face and base support.
3
Pre-drill the holes then use six #6-18 x 1" screws to
attach the brackets to the cabinet frame.
4
Place the microwave onto the bottom duct.
5
Insert the horizontal duct into the vertical duct to create
the rear duct assembly and secure with one #8-18 x
3
/
8
" screw.
6
Remove the existing screws from the upper right and
left rear of the microwave. Do not discard.
7
Position the rear duct assembly on the microwave and
secure using the screws removed in the previous step.
8
Position the three remaining duct sections on top of the
microwave to create the top duct assembly.
9
Secure each section with two #8-18 x
3
/
8
" screws (one
per side) and insert one #8-18 x
3
/
8
" screw in the top
section.
Convection Microwave - E Series Trim Installation
wolfappliance.com 800.222.7820
9020747 REV-A 04/2018
Page 1 of 2
*9020747$REVA*
To Next Page
Need help?
General
