Safetyandregulations
2 Safetyandregulations
The general safety instructions must be observed.
2.1 Intendeduse
The Link interface module is designed exclusively for use in conjunction with
Wolf products.
Intended use also includes observing all other applicable documents.
2.2 Incorrectuse
Any use other than the intended use is not permissible. Any other use or
changes to the product at any time including during assembly and installation
invalidate all warranty claims. The user has sole liability for such use.
This appliance is not intended to be operated by persons (including children)
with restricted physical, sensory or mental capacities or who lack the
necessary experience and/or knowledge, unless they are supervised by a
person responsible for their safety or have received instructions on how to
use the appliance from this person.
2.3 Generalsafetyinstructions
The Link interface module must be installed and commissioned by a
qualiedcontractor.
Onlyqualiedcontractorsmaycarryouttheelectricalinstallation.
X Before working on the electrical installation, disconnect the power supply
from the appliance and all connected components.
X Be aware that there is mains power to the electrics, even when the
appliance is switched off.
X Only replace damaged or faulty components with original WOLF spare
parts
X Do not remove, bypass or disable any safety and monitoring equipment
X Only run the system when it is in perfect technical condition
X Immediately rectify any faults and damage that impair safety
X If the domestic hot water temperature is set above 60 °C, install a
thermostatic water mixer
X Route mains power cables with a voltage of 230 V in a separate location
to the eBus cables
4
3066086_201803
To Next Page
Loading...
Need help?
General
