Servicing The Edger
General Information
Servicing The Edger EGdoc022715 1-1
1
SECTION 1 SERVICING THE EDGER
1.1 General Information
This documentation includes information on preparing the edger for operation and operating,
servicing and reparing the machine.
The EG250E15-EMR/EG300E20S-EMR (EG250E20-EMR/EG300E25S-EMR) Edger is designed for
sawing wood only (see the "Specifications" section in this manual for maximum wood dimensions).
The machine must not be used for other purposes, such as cutting ice, metal or other materials.
Using the machine correctly you will achieve high degree of accuracy and rate of efficiency.
The edger should be operated only by an adult (over 18 year old) persons who have read and
understood the entire operator's manual. The edger is not intended for use by or around children.
The machine is built to be durable and easy to operate and maintain.
1.2 Customer and Edger Identification
Each Wood-Mizer edger has a serial number. In addition, when you pick up your edger, you will
receive a customer number. These three numbers will help expedite our service to you. Please
locate them now and write them below so you have quick, easy access to them.
See Figure 1-1. The figure below shows an exemplary identification plate of the EG300 Edger.
FIG. 1-1
To Next Page
Loading...
