Sawmill Alignment
Complete Alignment Procedure
7
7-27 3097doc041910 Sawmill Alignment
10. Check the position of the blade on the drive-side blade wheel. The blade should be posi-
tioned on the wheel as described for the idle-side blade wheel. Adjust the drive-side blade
wheel if necessary.
LT30 rev. H3+/LT40 rev. H4+:
See Figure 7-22. Use the horizontal adjustment screws to adjust the drive-side blade
wheel. To move the blade back on the wheel, loosen the right adjustment screw one quar-
ter turn. Loosen the jam nut on the left adjustment screw and tighten the screw to 30
ft.-lbs torque. Tighten the left and right jam nuts.
To move the blade out on the wheel, loosen the left adjustment screw one quarter turn.
Loosen the jam nut on the right adjustment screw and tighten the screw to 30 ft.-lbs
torque. Tighten the left and right jam nuts.
NOTE: Sawmills prior to LT30 Rev. H4.00 and LT40 Rev.
H5.00 are equipped with socket set screws rather than hex
bolts. Adjustment of either type bolt is similar.
FIG. 7-22
djust horizontal adjustment screws
left to move blade in on wheel;
Adjust screws right to move blade
out on wheel
3H0802-14
To Next Page
Loading...
