MAINTENANCE
Safety Devices Inspection
4
4-5 doc072921 MAINTENANCE
4.6 Safety Devices Inspection
MP160E3S Planer/Thicknesser – Safety Devices Inspection
Safety devices on the machine which must be checked before every shift:
E-STOP button and its circuit inspection,
1. E-STOP button and its circuit inspection
Use “I” buttons to start cutter and feed rollers. The motors should start.
Press the E-STOP button no. 1 located on the control box. All motors should be stopped.
Pressing the “I” buttons should not start the motor until the E-STOP button is released.
Release E-STOP button no. 1. Use “I” buttons to start cutter and feed rollers. The motors
should start.
Press the E-STOP button no. 2 located on the front side of the machine (CE version only). All
motors should be stopped. Pressing the “I” buttons should not start the motor until the E-STOP
button is released.
Emergency
switch no. 1
Emergency
switch no. 2
To Next Page
Loading...
