How to troubleshoot low oil pressure alarm after crank disconnect in Woodward easYgen-400 Control Unit?
To troubleshoot a low oil pressure alarm after crank disconnect in your Woodward Control Unit, check the oil pressure sensor and its connections.
What to do if Woodward Control Unit genset running while ATS not transfer?
If the genset is running while the ATS (Automatic Transfer Switch) is not transferring in your Woodward Control Unit, check the ATS and the connections between the ATS and controllers.
What to do if my Woodward easYgen-400 shows controller emergency stop?
If your Woodward Control Unit indicates an emergency stop, verify that the emergency stop button works properly. Also, check whether the starting battery's positive pole is connected to the emergency stop input and whether the circuit is open.
What to do if my Woodward Control Unit experiences a shutdown alarm while running?
If your Woodward Control Unit displays a shutdown alarm while running, check the switch and its connections according to the information on the LCD. Also, check the auxiliary input ports.
Why does my Woodward Control Unit genset shutdown?
If your Woodward Control Unit's genset shuts down, check if the water/cylinder temperature exceeds the limits, the genset AC voltage, and the DC fuse.
What to do if Woodward easYgen-400 starter no response?
If the starter of your Woodward Control Unit doesn't respond, check the starter connections and the starting batteries.
What to do if my Woodward easYgen-400 Control Unit has no power?
If your Woodward Control Unit has no power, check the starting batteries, controller connection wiring, and the DC fuse.
General| Model | easYgen-400 |
|---|---|
| Digital Inputs | 8 |
| Digital Outputs | 6 |
| Analog Inputs | 4 |
| AC Frequency | 45-65 Hz |
| Communication Ports | RS-485, Ethernet |
| Display | LCD |
| Protection Class | IP20 |
| Supported Protocols | CANopen |
To Next Page
