Prime mover safety
WARNING!
Hazards due to insucient prime mover protection
The engine, turbine, or other type of prime mover should be equipped with an overspeed
(over-temperature, or over-pressure, where applicable) shutdown device(s), that
operates totally independently of the prime mover control device(s) to protect against
runaway or damage to the engine, turbine, or other type of prime mover with possible
personal injury or loss of life should the mechanical-hydraulic governor(s) or electric
control(s), the actuator(s), fuel control(s), the driving mechanism(s), the linkage(s), or
the controlled device(s) fail.
Modications
WARNING!
Hazards due to unauthorized modications
Any unauthorized modications to or use of this equipment outside its specied
mechanical, electrical, or other operating limits may cause personal injury and/or
property damage, including damage to the equipment.
Any unauthorized modications:
•
constitute "misuse" and/or "negligence" within the meaning of the product warranty
thereby excluding warranty coverage for any resulting damage
•
invalidate product certications or listings.
Use of batteries/alternators
NOTICE!
Damage to the control system due to improper handling
Disconnecting a battery from a control system that uses an alternator or battery-
charging device whilst the charging device is still connected causes damage to the
control system.
• Make sure the charging device is turned o before disconnecting the battery from
the system.
General notes
NOTICE!
Avoid electrostatic discharge!
Before working with terminals please read and follow the instructions of chapter ╚═▷
Chapter 1.2.3.2.
11easYgen | exciter-10B37910
1 General information
1.2.3.2 General Safety Notes
To Next Page
Loading...
Need help?
General
