Manual 26181 EGCP-2 Communications
Woodward 21
ServLink Variable List
The ServLink variables are divided into
five Category folders. The first four folders
contain information to be read from the
control. The SPt, or Setpoint folder,
contains the setpoint menus, where
tunable setpoints can be adjusted.
<< No Category>> Information
Under the <<no category>> heading are
12 Blocks of variables. Some of these
folders will contain information which is
not useful, such as
Begin Programming Mode,
End Programming Mode,
Front Panel,
Reset,
Save Values,
Shutdown,
Write Program Memory.
To Next Page
Loading...
