12
Maintaining your Boiler
GREENSTAR HIGHFLOW CDi
ErP
– 6 720 815 063 (2015/05)
AIRING CUPBOARD CLEARANCES
If the boiler is fitted into an airing cupboard then the diagram opposite shows the minimum clearances required around the boiler
and also the clearances for any shelf constructed above the boiler.
If a compartment is built around the boiler after installation, then the compartment must be separated from the boiler space by a
noncombustible partition as described in BS 6798.
Fig. 8 Airing cupboard clearances
[**] This space can be reduced to 50mm for one side only as long as both side clearances add up to the total of both the side
measurements shown, or more.
[***] Space required for airing cupboards with a removable door or panel, but 600mm to a fixed surface for servicing.
6 MAINTAINING YOUR BOILER
Your new gas-fired boiler represents a long term investment in a reliable, high quality product.
Wipe the boiler casing with a soft clean cloth. Please do not use chemical cleaning products which may damage the paint finish.
In order to realise its maximum working life, and to ensure it continues to operate at peak efficiency and performance, it is essential
that your boiler receives regular servicing and maintenance checks from a competent person beyond the initial two year guarantee
period.
If your Greenstar gas-fired boiler should fail to operate correctly or requires servicing, please contact the Worcester, Bosch Group
Appointments Team (see rear cover for details).
Details of the boiler including the Gas Council number can be found on the front cover of these User Instructions and on the boiler
identification label on the boiler fascia.
The Gas Council number is also listed on the front cover of your Installation, Commissioning and Servicing Instructions.
6720806267-11.1Wo
8
0
0
m
m
10
0
m
m
**
10
0mm
**
62
5m
m
10
0m
m
1
05
0
m
m
2
00
m
m
2
5m
m*
**
To Next Page
Loading...
Need help?
General
