Operation upon PARs
6.5 Program or record a PAR Scene / Chase
6.5.1 Program / record a PAR Scene
(1) Press and hold down the RECORD button for about 5 seconds to enter the
CHASE/SCENE mode. Then choose the Scene page by UP or DOWN button.
(2) Select and press a Scene button to be recorded, its LED will begin to blink quickly. LCD
will show you as below:
EDIT SCENE× / PG××
SAVE
ESC PAGE××
(3) Set a scene by faders. User can also insert a recorded scene for new scene setting.
(4) Press RECORD button to record this scene, all LEDs will flash suddenly. User can then
set and record another Scene as desire.
Note: In Record mode, user can delete a PAR Scene. Select and press a recorded Scene
button in the Record mode, its LED will blink quickly. Then press the DEL button to delete
the scene, all LEDs will blink suddenly. (Press ESC button to exit.)
6.5.2 Program / record a PAR Chase
(1)
Press and hold down the RECORD button for about 5 seconds to enter the CHASE /
SCENE mode.
(2) Select and press a Chase button to be recorded, its LED will begin to blink quickly. LCD
will show you as below:
EDIT CHASE× / TL××
ADD
ESC STEP××
(3) Use UP or DOWN button to select the Chase Step to be programmed.
(4) Set a scene for Chase recording.
(5) Press the RECORD button, all LEDs will blink briefly, and LCD will show you the new
step.
(6)
Pressing the DEL button can delete the current step, all LEDs will blink briefly.
(7)
User can press ESC button to exit .
6.6 Select or deselect a PAR Scene / Chase
6.6.1 select / deselect a PAR Scene
(1)
Press the PAGE button, its LED will be lit, you can select t scene page by UP/DOWN
button. PAGE:×× will be shown on the top left corner of the LCD-display.
(2) If the Scene LED is “on”, that means the scene was programmed. While “off ” means
unprogramed. Press the programmed Scene button to reactivate the PAR Scene.
(3)
Pressing the scene button again can disable the related Scene.
10
To Next Page
Loading...
