Work Pro Nemesis 136 - Select; Deselect a Fixture Chase; Delete a Fixture Chase

• Select Chase speed mode
Press a programmed Chase button, its LED will be lit to indicate its Speed mode. Fast
flashing means user can set the speed by SPEED Slider or the TAP SYNC button,
while slow flashing means the Chase speed has already been programmed (Speed
adjusting will be of no effect at this moment). User can switch the Chase speed
mode by pressing the “STEP/MIX/SEQ” button while pressing and holding
down the programmed Chase button. ( the priority of Chasing sequence keeps
unaffected.)
•
Operate relevant chase by faders
You can control any of the channels by faders while the chase running. If you want to
return to its former track, please press any of the chase button .
All scenes are disabled when chases running.
• STEP
Press STEP button, the chase will step forward while the program running.
• AUDIO
Press AUDIO button while chase running, the AUDIO LED will light up, that means
you have entered the “AUDIO” mode. FADE TIME will be useless, and the “TAP
SYNC” LED will blink according to the audio effect.
• FADE TIME/SPEED
If the chase runs under the SPEED MODE which set by the SPEED slider or TAP
SYNC button, you can then use the SPEED and FADE faders to control SPEED and
FADE TIME.
• PAN/TILT FADE ONLY
You can select relevant channel only for PAN/TILT, or select all channels for FADE
TIME.
6.4 Delete a Fixture Chase
(1)
Press RECORD button for about 5 seconds to enter CHASE/SCENE mode.
(2)
Select the Fixture Chase to be deleted, relevant LED will flash fast.
LCD shows:
EDIT CHASE× / TL××
ADD ESC STEP××
(“TL××” means “TOTAL” )
(3)
press the “DEL” button while pressing and holding down the Chase button
simultaneously, the chase will be deleted within few seconds (all LEDs will blink
suddenly).
(4)
Press “ESC” to exit.
9