6.6.2 select / deselect a PAR Chase
(1) Choose chase mode:
Press ONE/MIX/SEQ button to select the chase mode when no chase running. “off ” LED
means “ONE” mode, “on” LED means “MIX” mode, and “flashing” LED means “SEQ”
mode. It would be ineffective when chase running.
(2) “ONE” mode:
Enter this mode, then press the programmed chase button, the relevant LED will light up.
The other running PAR chases will be closed.
close all the running chases when exit this mode.
(3) SEQUENCE mode:
In this mode, you should press the programmed chase buttons in turn to operate the
chases. The relevant LEDs will flash when chases are running.
Close all the running chases when exit this mode.
(4) MIX mode
In this mode, chases can run at the same time. The relevant LEDs will light up when
programs running. You should close all the running chases when exit.
(5) AUDIO
Press AUDIO button while chase running, the AUDIO LED will light up, that means you
have entered the “AUDIO” mode. FADE TIME will be useless, and the “TAP SYNC” LED
will flash according to the audio effect.
(6) STEP
Press “STEP” button, the relevant LED will blink briefly, and the chase will go forward for
one step.
(7) FADE TIME / NO FADE TIME
Press “FADE+SPEED” to select “FADE TIME / NO FADE TIME”.
FADE TIME and SPEED can interact on each other jointly.
(8) STAND BY
Press this button will shutter the PAR’s output during operating.
6.7 Delete a PAR Chase
(1) Press RECORD key to enter CHASE/SCENE mode.
(2) Select the PAR Chase to be deleted, and the relevant LED will flash fast.
LCD shows:
EDIT CHASE X/TL××
ADD ESC STEP××
(3) Press the corresponding Chase button and “DEL” button simultaneously, and then the
Chase can be deleted within few seconds.
(4) Press ”ESC” to exit.
11
To Next Page
Loading...
